[[ImgSrc-search]]
Contact Us
Office Mob: +8618002480485
Office Tel: +86-024-31140175
Office Fax: +86-024-22845391
E-mail: info@eoexport.com
Address: Second Floor, No.29 Shiyiwei Road, Heping Liaoning Shenyang.
Home > News > Content
Maintenance Of Electric Bicycle Batteries
Jul 25, 2017

Qualified electric bikes used by the battery manufacturers after the factory, the battery life and performance depends in part on the use and maintenance of consumers.

(1) Charger and battery match.

Electric Bicycle battery is charged with the bad, not with the bad, visible charger and battery match the importance of here, there are two cases: First, the new charger itself and the battery manufacturers to provide the parameters do not match, the second is charging Device itself, the quality of components, the beginning of the use, still match, with the consumer charge, discharge cycle, the charger itself due to temperature rise, component aging, resulting in charging voltage and conversion current drift, the battery is damaged The

(2) regular, timely replenishment.

Consumers on the use of the instructions of the nominal life cycle is usually a misunderstanding that the charge once the battery life is reduced once, so each time the battery power consumption to the controller to protect the voltage of 31.5V began to recharge , Not knowing that this will not only protect the battery, but also shorten the battery life. So to remind the vast number of consumers, where possible, should be promptly to the battery to recharge.

(3) It is forbidden to continue to ride under the condition of undervoltage. Some consumers riding on the halfway, the light shows the situation after the undervoltage, take a break and then ride a section of the way, so that the great harm to the battery, a serious over discharge will make the battery salted or generated lead Crystal, short circuit the battery, affecting life.

(4) electric bikes just start, climbing, overload should try to help.

(5) rain riding, should try to avoid the switch and joints wet, to prevent leakage.